If you are running a regular distributor, have you checked the points and condenser? This can cause the same issue.
I removed mine from the top, it wasn't easy, but doable. The Steering wheel will need to be removed to maneuver around the seat.
1970 original paint and emblem[ATTACH] Just kidding.
I rebuilt mine a few months back, Novak was on back order at that time. I sourced all the parts of the internet because I wasn't in a hurry and...
contact Brian Hainer at metalshaper@comcast.net. He sells all the lubricants for our Jeeps.
Yes sir, the welds are straight up and down. We plated on both sides interior of the square tube drilling 1/2" into the tube and spot welding....
Thanks. I didn't remember it being offset, and just wanted to make sure before we go any further with getting the angles set.
I guess I need to clarify what I am seeking. Not too worried about the driveshaft angle. I can correct that. I don't remember the angle of the...
I am in the process of building a 1975 cj5. We fabricated a new frame with 4x2 steel tube. Rebuilt the 258, t14 and dana18. Now the fun part of...
I just rebuilt both the T14 and dana 20, they came apart quite easily. There is a bolt that sits the bottom half of the transfer case that can be...
Great score, I found my 70 in a barn 5 years ago and just do little things to keep it running. The dauntless hadn't been started in 10 or more...
x2. I just rebuilt mine a few months ago and had to replace the sector shaft, so marking would not have helped. When I opened my box, half of the...
You can pull the box out from the top. Remove the floor pans, and then remove the bolts from the master cylinder to help give you a little more...
I grab the measurement's off my 70 and 75 tonight unless someone gets to it before me.
Separate names with a comma.
