the casting is not on the greatest of shape on the milled surface.That may also be causing the pulling out issue.I guess it is one more reason for...
yes I am but I probably should not insert to the point that it hangs out the back side right?
if the helicoil was set past the back thickness of the casting, would this cause failure?
Wow, there a lot to choose from. I am kinda confused on which I should go with.any suggestions on how I should figure that out?
I will look into these more.I really appreciate the responses. gotta get her back together quick. gonna be snowing and no plow Uht oh.
Hey all, I am having a nightmare with 2 helicoils on my exhaust/intake manifold.The hole have been helicoiled before and the tap does not seem to...
Good point Case. Didn't think about sealing the helicoil threads. Thanks a million ....Dave
I have to put a helicoil in my block for the mainfold stud. Question is do I need to worry about the "Tang" dropping into the water jacket? I...
Another possibility may be your oil is thinned out fromrepeated no starts. Check the oil to see if it smells like gas.
Ok, The voltage reg on my cj looks like toast. The windings are burnt up and it is not charging. My main concern is that I am not sure that the...
I did the same thing. Stuck some wire up there and fuel finally came out.Hooked her up and no problems since!
I have a bottom feeder tank on my Cj. My question is This feeds by gravity to the fuel pump Correct? I think I have a clog in either the...
Separate names with a comma.
