I'm trying to set up hei, on my 225. I've been reading allot of articles and posts on here and other forms. One thing, I can't seem to get a clear...
Looking to remove my tub, but I can't figure out the removal of my steering system. This jeep was built by the previous owner so I am not certain...
Went to fire it up back in April, came across a rusty gas tank, decided poly was the right replacement, also this shot shows the new floor pans...
Did a little more investigation, it will start when trying to bypass the switch and I believe it will stay running without the start wire, I am...
I have a CJ3A that has a dauntless motor swapped, in regards to the actual wiring of the ignition I thought this might be the best location to...
It was a long winter, not working on the Jeep, finally got some garage time this afternoon and got a lot of progress in putting this back...
Here are few more, figured I would make both floor supports at the same time. [IMG] [IMG] Here is that wiring kit some what installed [IMG]
Got what seems like a lot of progress done over the last month, without working any weekends and now its starting to get cold. I started off going...
Did a little work early this morning, I had some time away from the jeep so not much has gotten done. I ordered parts for the passenger side I...
I am planning on only doing one side at a time, both due to space and complexity. Th driver side is better in this location, but worse under the...
Got some work done this weekend. Cutting out the old and sizing up for how much repair I need to do. Removed the Tool Box [IMG] [IMG] Found...
Found these on a different forum...I might try to duplicate it. [IMG] [IMG]
Has anyone used angle iron in replacement of rectangle tubing?
Separate names with a comma.
